Changes made to Adaptive Clearing for Mastercam

2.1.1: (5. October 2006)
===============================================================================

  - disabled of lock of operation length and diameter offset to tool in tool
    table.

  - added support for smoothing deviation for finishing passes for pocket 2D.

  - updated Finnish locale.

  - fixed F0 problem for adaptive clearing.

  - fixed legacy coolant support.

  - added support for radius compensation for finishing passes for pocket 2D.

  - added support for trochoidal cutting for pocket 2D.


2.0.6.5852: (19. July 2006)
===============================================================================

  - added linking parameters on the surface dialog page.

  - added partial support for solid chains. solid chains can be added from the
    chain manager.

  - fixes for pocket 2D.


2.0.5.5804: (13. July 2006)
===============================================================================

  - added support for entry and predrilling point using the chain manager.

  - added ramping strategies for pocket 2D.

  - added support for retract height for the adaptive clearing strategies.

  - removed small helical segments for the adaptive clearing ramps.

  - the keep down distance for the adaptive clearing strategies can now be set
    manually using the keep contact parameter on the surface dialog page.


2.0.4.143: (22. March 2006)
===============================================================================

  - add support for multiple contours for 2d pocket. each group of contours
    which share the same Z-level are treated independently.

  - fixed smooth transitions for 2d pocket.


2.0.3.142: (21. March 2006)
===============================================================================

  - fixed 2d adaptive clearing problem when using boundaries with connected and
    parallel linear segments.


2.0.2.141: (20. March 2006)
===============================================================================

  - fixed 2d adaptive clearing problem when wall taper angle was set to 0.


2.0.1.140: (16. March 2006)
===============================================================================

  - added 2d pocket and 2d adaptive clearing strategies.


1.3.1.139: (14. March 2006)
===============================================================================

  - fixed memory usage problem when using high curvature NURBS as boundaries.


1.2.9.138: (21. December 2005)
===============================================================================

  - updated tool creation behavior when importing parameters for a file.

  - added support for Mastercam X SP2.

  - changed Mastercam X category to "Adaptive - CIMCO Integration".

  - improved the adaptive clearing toolpath.

  - updated Finnísh locale.

  - fixed wrong backplot view problem.

  - added option for disabling output of operation parameters to nci section.

  - fixed reset of coolant problem for operations.


1.2.8.137: (4. October 2005)
===============================================================================

  - Added support for Mastercam X.

  - Updated user interface.

  - Added flat area machining support.


1.2.7.136: (27. July 2005)
===============================================================================

  - Release.